What's new

Jovy RE-7500 User Manual

ThienBui

Techniques
Supporter
RE-7500.png

This unit operates by electricity. And some components within the

device have high dangerous voltages applied to them.
• Failing to follow the operating instructions could result in death,
serious injuries, and/or extensive damage to property!
• Never open the housing or one of the Infrared heaters while main plug
is connected.
• Do not use the units for any purpose other than which they are
intended to. Use it according to the operating instructions.
• This equipment must not be switched on or used without supervision.
• The unit should switched‐off or in idle state while not in use, leaving it
ON may cause overheating.
• Do not place any flammable material on the vicinity of the Infrared
heater.
• Do not allow the spillage of any liquid to on the ceramic emitter as
damage may occur.
• Please use the Infrared heater only on a level and non flammable
surface.
• When the Infrared heater is in use, its housing and the areas exposed to
the infrared rays can reach high level of temperature. Please do not
touch the housing until it cooled down.
• Any maintenance of the units is only permitted by a JOVY SYSTEMS
certified service technician.
• Please also pay attention to the safety regulations applied in your area.
 

Download list

RE-7500-Manual-English.pdf
2 MB · Views: 37

hello the bottom heater has a built-in K type sensor thermocouple elstien T-SHT 600 watts does any one know what is the resistance of the sensor from the heater i have an open circuit, I guess that where the machine is not working well
if anyone has the same machine heater can please measure the resistance
thanks
 
okay everyone who has jovy 7500 and get erratic temp readings first check your top thermocouple and also remember the heater has a integrated thermocouple and the resistance should be 0.3ohms to 0.7ohms and heater resistance should be 63ohms so i changed my 600watt heater to 800watts and now the machine works like new . also i try and copy the firmware from the mcu and put it up
thanks all
 

Latest posts

Back
Top