lenovo t480 dead efter program bios chip

hi
i program bios chip for lenovo t480 and finish without problems
but the labtop is dead
who know why

 

[ThienBui]

hi
i program bios chip for lenovo t480 and finish without problems
but the labtop is dead
who know why

before where Programming laptop how ?

 

[Hani002]

i use svod3 and write the bios file from this site
when it finish the labtop dead.
after that i write the old file but the same problem

 

[ThienBui]

i use svod3 and write the bios file from this site
when it finish the labtop dead.
after that i write the old file but the same problem

it is problem tool Programming for you.
check it

 

[Hani002]

i use another tool
but the same

 

[ThienBui]

i use another tool
but the same

that's the only problem you need to check and fix.

 

[E1LM]

i use svod3 and write the bios file from this site
when it finish the labtop dead.
after that i write the old file but the same problem

Maybe it's not bios problem ... do you have some measurements taken?

 

[jackbor]

first desolder the bios chip from the disc. then put it in the programmer and then unlock the chip and program it.
on the board you can not because the voltage on the circuit is too low. the part plate steals and there will always be an error.

 

[jackbor]

desoldering chip then flash.

 

[erwin07]

If you have the backing of the original bios the machine should turn on again, but also check well.

 

[tradexi]

LENOVO T480. NO DISPLAY

 

[ThienBui]

LENOVO T480. NO DISPLAY

builds3.zip

 

[Reer Indonesia]

Lenovo T480-STUCK ON LOGO .

 

[ThienBui]

Lenovo T480-STUCK ON LOGO .

builds3.zip