lenovo t480 dead efter program bios chip

Hani002

Registered member
May 23, 2018
6
0
44
Danmark
i use svod3 and write the bios file from this site
when it finish the labtop dead.
after that i write the old file but the same problem
 

jackbor

Registered member
Jun 3, 2019
3
1
39
Poland
first desolder the bios chip from the disc. then put it in the programmer and then unlock the chip and program it.
on the board you can not because the voltage on the circuit is too low. the part plate steals and there will always be an error.
 

New posts